HH Electronics SCALAR SR Series, Manual

Page: 12 / 20

11. OPERATION MODE SELECTOR; use this switch to change the operation mode of the amplifier.
Stereo mode: Both channels are independent of each other, acts as two separate amps.
Parallel mode: Connect to the input on CH1, the signal is sent to both CH1 and CH2 outputs. CH 2 input is not
active. Acts as two separate amps but with a common input.
Bridge mode: Connect to CH1 input, the signal is sent to both CH1 and CH2 positive ports, acts as a single
more powerful amp.
12. CHANNEL 1 COMBI INPUT; balanced input socket for use with either XLR or Jack.
13. CHANNEL 2 COMBI INPUT; balanced input socket for use with either XLR or Jack.
14 . CHANNEL 1 LINK; this socket is in parallel with CH1 Combi Skt and provides an output signal same as
the input signal.
15. CHANNEL 2 LINK; this socket is in parallel with CH2 Combi Skt and provides an output signal same as
the input signal.
SR SERIES SETUP CONNECTIONS
Connections to all amplifiers in the series are made using the same types of connectors as illustrated below.
Signals can be inputted using an XLR or a 6.3mm jack.
The input signal can be supplied to another device through a Male XLR in the Link Skt.
Connections to the speaker cabinets can be made via Speakon connectors or Binding posts, unless in Bridge
mode where only the binding posts can be used.
CH 1 Input
XLR or Jack
CH 2 Input
XLR or Jack
Speakon™
Speaker Cabinet
Binding Post
Link - Male XLR
Link - Male XLR