Introduction
LD900 Installation and Oper ations M anual
13
1.9 Equipment Care
1.9.1 Unpacking and Inspection
Caref ully unpack and inspect the unit. If the equipment appears damaged, contact VERIPOS for further advice
ensuring to retain the original packaging. Responsibility for damage will not be accepted if approved packaging
is not used. Ensure all the major items and the ancillary equipment are supplied. If any items are found to be
missing, contact the VERIPOS or system supplier as soon as possible.
1.9.2 Safety Warnings
Always observe the following safety precautions:
•
Ensure adequate air circulation to ventilate the unit, especially to the sides to avoid heat build-up.
•
Connect only to a power supply with a voltage within the range 12V to 24V DC.
•
Always
disconnect the LD900 from the power source when connecting equipment.
•
Never use the equipment in damp or wet conditions.
•
Avoid excessive heat, humidity, dust or vibration.
•
Do not use where the equipment may be subjected to dripping or splashing liquids.
•
Always use the power connections supplied with the unit.
•
Bef ore replacing a fuse,
disconnect the equipment from the power source
.
1.9.3 Installation
During installation ensure the following:
•
DC power supply is disconnected. The power connection is easily accessed on the unit rear.
•
The unit is secured using the holes in the base plate. Position the unit to ensure there is ample spacing
f or access to the front interface panel and adequate ventilation during normal operation.
•
All cables are routed safely to avoid sharp edges, excessive bends and pinches.
•
Only the cables specified within this manual are used for interconnection of the equipment.
•
Ensure equipment is connected to the ships ground.
1.9.4 Maintenance
Clean the unit using a clean dry cloth only. Do not wet the unit or allow the penetration of water. Do not use
solvents to clean the unit.
1.9.5 Servicing
This unit contains no user-serviceable parts. Please refer all repairs to a qualified service agent or VERIPOS.
1.9.6 Fault Diagnosis
Follow the guidance in this document to correctly install the LD900. Where the LD900 does not perform as
indicated firstly check all connections before contacting your supplier or VERIPOS for assistance.
