Introduction
LD900 Installation and Oper ations M anual
10
1.7.2 FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interf erence that may cause undesired operation.
LD900 has been tested and found to comply with the radiated and conducted emission limits for a Class B
digital device. The Class B limits are designed to provide reasonable protection against harmful interference in a
residential installation.
The equipment listed generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interf erence to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
•
Re-orient or relocate the LD900
•
Increase the separation between the equipment and the LD900
•
Connect the equipment to an outlet on a circuit different from that to which the LD900 is connected
•
Consult VERIPOS for help
CAUTION
To maintain compliance with the limits of a Class B digital device, you must use shielded interface
cables
WARNING
The LD900 has been authorised for use in Mobile applications. At least 20 cm (8 inches) of separation
between the LD900 and the User must be maintained during normal operation.
WARNING
Changes or modifications to this equipment, not expressly approved by VERIPOS could void the
user’s authority to operate this equipment.
1.7.2.1
Wi-Fi
LD900 contains a Wi-Fi radio with the following approval:
•
FCC ID: Z64-WL18SBMOD (USA)
