SHEET TITLE :
SHEET NO. :
NOTICE:
HexaCrafter ltd. reserves proprietary
rights to this drawing and data shown
thereon. Said drawings and/or data
are CONFIDENTIAL and are not to
be reproduced for any purpose
without the written consent of
HexaCrafter ltd.
ISSUE / DATE:
DRAWN BY:
01-17-2017
ARR
HexaCrafter ltd.
2750 Northampton Road
Cuyahoga Falls, Ohio 44223
(330) 929-0989
www.hexacrafter.com
HEXACRAFTER ONLINE ASSEMBLY VIDEOS & PHOTOS:
PLEASE VISIT OUR WEBSITE: www.hexacrafter.com FOR DETAILED ASSEMBLY VIDEOS & PHOTOS.
CONTACT HEXACRAFTER FOR ASSISTANCE OR WITH BUILD QUESTIONS.
DETAIL: POWER PLATE ASSEMBLY
STEP 6B- 15MM LOAD RAILS
QXSEPP OCTOCOPTER
ELECTRICAL POWER PLATE
SHCS-3X8 OR 3X10
HEX CAP SCREW
SHCS-3X30
HEX CAP SCREW
LRMB-12
LOAD RAIL MOUNTING BRACKET
RGF12
RUBBER GROMMET
12MM OR ASSEMBLED 15MM
CARBON FIBER LOAD RAILS
USE THESE HOLES FOR
60MM LOAD RAIL SPACING
USE THESE HOLES FOR
80MM LOAD RAIL SPACING
KLR15
LOAD RAIL ADD-ON ACCESSORY
(SHOWN)
KLR-10 & KLR12
LOAD RAIL ADD ON
ACCESORIES ALSO AVAILABLE- REFER TO
ADD-ON ACCESSORIES ASSEMBLY MANUAL
3MX15FFAL OR 3MX20FFAL
HEX
STANDOFF BASED ON USER
CLEARANCE REQUIREMENTS
THREADLOCK COMPOUND RECOMMENDED
QLRRP - QUADCOPTER LOAD RAIL
REINFORCEMENT PLATE PLATE- ADD-ON
OPTIONAL ACCESSORY- USE WHEN HEAVY
LOADS WILL BE APPLIED TO LOAD RAILS-
CONTACT HEXACRAFTER FOR INFORMATION
QXS-5A
QXS SERIES
AIRFRAME
ASSEMBLY
MANUAL- PAGE 5A
DETAIL: POWER PLATE ASSEMBLY
STEP 6C- OPTIONAL LANDING GEAR STRUTS
QLRRP - QUADCOPTER LOAD RAIL
REINFORCEMENT PLATE PLATE- ADD-ON
OPTIONAL ACCESSORY- USE WHEN HEAVY
LOADS WILL BE APPLIED TO LOAD RAILS-
CONTACT HEXACRAFTER FOR INFORMATION
3MX23FFAL
HEX STANDOFF
SHCS-3X8
HEX CAP SCREW
RLGSP RETRACTABLE
LANDING GEAR STRUT PLATE
DETAIL: 15MM LOAD RAIL TUBES
STEP 6A- 15MM LOAD RAIL TUBE ASSEMBLY
CLR-12
12MM TUBE SECTION
CLR-15
15MM TUBE SECTION
CLR-12
12MM TUBE SECTION
APPLY EPOXY TO INSIDE OF
TUBE FROM EACH END.
GLUE INTERIOR TUBES TO MEET AT
MIDPOINT OF 15MM TUBE
INSERT 12MM TUBES INTO WET EPOXY ON THE INTERIOR
OF THE 15MM TUBE. ROTATE AND SLOWY WORK INWARD
AND OUTWARD WHILE INSERTING TO ENSURE EVEN
COVERAGE OF EOPXY TO BOTH TUBES
INSERT 12MM TUBES INTO WET EPOXY ON THE INTERIOR
OF THE 15MM TUBE. ROTATE AND SLOWY WORK INWARD
AND OUTWARD WHILE INSERTING TO ENSURE EVEN
COVERAGE OF EOPXY TO BOTH TUBES
