Hewlett Packard Enterprise Aruba 9012, Installation Manual, Page: 11 / 26

Aruba 9012 Gateway
| Installation Guide 9012 Gateway |
11

STATUS : Placed on the right side of the port, and displays the status of the port based on the
CLI.
The following table describes the LED behavior for each mode:
Micro-USB Console Port
The Aruba 9012 gateway is equipped with a Micro-USB (type B) connector that provides direct
local console access. If both Micro-USB and RJ-45 console ports are connected, the Micro-USB
connection takes precedence over the RJ-45 console connection.
Micro-USB Driver
To use the Micro-USB console port, you must install the Aruba Micro-USB driver on the computer
that will manage your gateway. To download the driver, perform the following steps:
1. Go to
https://support.arubanetworks.com .
2. Click on the Tools & Resources tab.
3. Open the USB Console Driver folder.
4. Open the Mobility Gateway and Mobility Access Switch folder.
Select the appropriate file for your application. The corresponding operating system is in the file
name.
RJ-45 Console Port
The serial console port allows connecting a gateway to a serial terminal or a laptop for direct local
management. This port is a RJ-45 female connector with the pin-outs descried in Figure 4 .
Connect it directly to a terminal or terminal server using an Ethernet cable.
Table 5
10/100/1000BASE-T Ethernet Port LEDs
LED Function Mode Indicator Status
LINK/ACT Link status NA Green (Solid) Link established
Green (Blinking) Port is transmitting or receiving
data
Off No link
STATUS Port status Speed Green (Solid) Link at 1000 Mbps
Off Link at 10/100 Mbps