U
SER’S MANUAL |
ERGO-S
19
Figure 17. Pulling the gripper upwards whilst keeping the clip pressed
7.2.2 Mounting the Charger
To mount the charger to a wall/panel after the grippers have been removed:
1. The location must be defined and two holes aligned vertically 52mm apart must be drilled to accommodate maximum M6 Hex or Allen
bolts.
2. Align the drilled holes with the ones in the charger and use the chosen bolts/screws to hang and tighten it in place.
Note:
When mounting the charger to a panel with hex bolts, the hex bolt head can seat inside the slots available in the charger so that it
can be tightened using nuts from behind the same panel.
3. The grippers can then be placed in the charger and pushed downwards until the clip snaps in place.
7.3 Battery Disposal
AVOID ENVIRONMENTAL POLLUTION. Recycle your rechargeable batteries according to local recycling rules and regulations. If you
have questions or problems operating your battery charger, please contact your nearest Hetronic dealer or service center.
Standard Hetronic rechargeable batteries are the Lithium
–Ion type. These batteries have no “memory effect” when charging a battery that
is not fully discharged.
7.4 Prolonged Battery Life
Avoid battery misuse, over charging, overheating or regular dropping. This can cause permanent damage to the cells. Refer to Section 9
(Table 4) for battery specifications.
Never keep a fully charged battery at elevated temperatures. Battery pack does not die suddenly but the runtime gradually
shortens as the capacity fades.
Keeping the charge in the 40% to 80% range will prolong battery life.
Unfortunately there is no avoiding fact that battery has a finite life, after which they will certainly degrade. Following th ese basic tips can
help delay the inevitable.
5
2
m
m
Ø6mm (max)
