2
Operating instructions Heta vision I, II and III
INSTALLATION INSTRUCTIONS
Safety clearances
Stoves must always be installed in line with
national and, if applicable, local regulations.
It is important to abide by local regulations
regarding setting up chimneys and connec-
tion to same. Therefore, always consult your
local chimney sweep before installation, as
you are personally responsible for ensuring
that the applicable regulations have been
met.
Distance regulations
A difference applies to installation next to
flammable and non-flammable walls. If the
wall is made of non-flammable material
the stove can, in principle, be placed flush
against it. However, we recommend leaving
a gap of at least 5 cm to facilitate cleaning
behind the stove. The minimum distances to
flammable material are stated on the boiler
plate and are listed in the table on page 5.
Warning
A stove gets hot. (In excess of 90
degrees). Take care to ensure that
children and elderly or infirm people
cannot come into contact with it.
Combustible materials should not be stored
in the compartment below the ashpan.
IMPORTANT
1. Make sure there is adequate provision to
sweep the chimney.
2. Make sure there is adequate ventilation to
the room.
3. Please note that any extraction fans opera-
ting in the same room as the wood-
burning stove can reduce the chimney
draft – which may have an adverse effect
on stove combustion properties.
In addition, this may cause smoke to be
emitted from the stove when the firing
door is opened.
4. It must not be possible to cover any air
vents.
The floor
It is essential to ensure that the floor surface
can actually bear the weight of the stove and
a top-mounted steel chimney, if applicable.
The stove must stand on a nonflammable
surface such as a steel floor plate or a brick
or tile floor. The size of the nonflammable
surface used to cover the floor area must
match national and local regulations.
The wall-mounted Vision III underlying sur-
face is subject to the same regulations.
In addition, the Vision III must be mounted at
least 7 cm above floor level
Congratulations on your new stove. We are sure that
you will be happy with your investment, especially if
you follow the advice and instructions we have put
together in these operating instructions.
The Heta Vision series has been approved according
to the EN 13240 / NS 3058.
Approval means that consumers can be sure, that the
stove meets a range of specifications and require-
ments intended to ensure that the materials used are
of good quality, that the stove does not adversely af-
fect the environment, and hat it is economical to use.
With your new stove you should have received the
following:
a. Operating instructions
b. Guarantee slip
c. A stove glove
d. Decorative cover
e. Fireplace set (3 things - not Vision II and III)
