hestan ASPIRE AEB Series, Use & Care Manual

Page: 14 / 40

©2017 Hestan Commercial Corporation
13
EN
GAS CONNECTION - LIQUID PROPANE (LP) CYLINDER
Should you wish to connect your Aspire Side Burner to a standard 20 lb. LP gas cylinder, you will need to
order kit AGCKLPT. This kit includes a two-stage regulator/hose assembly for connection to the tank,
and a tank retention device. This regulator/hose assembly must be used WITHOUT alteration. If this
assembly needs to be replaced, contact your Hestan dealer for genuine replacement P/N 014309.
NOTE: To ensure proper heating performance of this appliance, verify that the supply pressure is
adequate. Use only the gas pressure regulator supplied with this appliance. This regulator is set for a
supply pressure of 11 inch WC (2.74 kPa) to maintain 10 inch WC (2.49 kPa) outlet (manifold) pressure.
TO CONNECT THE REGULATOR / HOSE ASSEMBLY FOLLOW THESE STEPS:
1. Locate the regulator and gas connection point in the rear right side of your side burner.
2. Connect the 3/8” Flare (compression flare fitting) X 1/2” NPT female adapter as shown. Then connect
the regulator/hose assembly to the adapter as shown. Use appropriate thread sealant on all connections.
3. Connect the regulator/hose assembly to a standard 20 lb. LP cylinder. The hose as well as the connectors
must comply with the Standard for Connectors for Outdoor Gas Appliances and Manufactured Homes,
ANSI Z21.75 • CSA 6.27, and suitable for outdoor installation. Use the appropriate thread sealant on all
connections.
4. Proceed to LEAK TESTING section.
GAS AND ELECTRICAL CONNECTIONS
(continued)
2-STAGE LP
REGULATOR /
HOSE ASSEMBLY
20 lb. LP TANK
(SUPPLIED BY
CUSTOMER)
ELBOW & NIPPLE
(SUPPLIED BY CUSTOMER)
ASPIRE SIDE BURNER
(MODEL AEB122-LP SHOWN)
ADAPTER, 3/8 FLARE
X 1/2 NPT FEMALE
(SHIPPED LOOSE)
RETENTION
DEVICE
(SHIPPED LOOSE)