ELECTRICAL RATINGS
Continuous Duty
FOR SOLENOID
24 VDC (+ 10%)
12 VDC (+ 10%)
Resistance in Ohms
100
25
Watts Seated
6
6
Amps Seated
.24
.48
-
CAUTION!
Before connecting any device at the installation site, verify input voltage and current using a
multimeter. Many power supplies and transformers operate at higher levels than listed. Any input voltage
exceeding 10% of the solenoid rating may cause severe damage to the unit and will void the warranty.
For any questions regarding this information, call our Technical Service Line at 1-800-626-7590
Solenoids are rated at +/- 10% indicated value
FIVE YEAR LIMITED WARRANTY
1006 LATCHBOLT MONITOR:
LBM
WIRING COLOR CODE
White - Common
Orange - NO (normally open)
Green - NC (normally closed)
LBSM
WIRING COLOR CODE
Brown - Common
Blue - NO (normally open)
Yellow - NC (normally closed)
• U.L. and U.L.C. listed for
fire door accessory, category
10C (file #843X), for use with 3
hour “A” labeled doors (fail
secure only)
• U.L. listed for burglary
resistance, category 1034
(file #51WK)
• ANSI A250.13-2003
Windstorm Resistant
U.L. Tested
Standard UL 1034 listed for:
• 1500 lbs. static strength rating
• 70 foot-lbs dynamic strength
rating
• 250,000 cycles endurance rating
Note: At the request of HES this
model was tested and verified by
UL for the following voluntary
(not required) ratings:
• 3,000 lbs static strength rating
• 2,000,000 cycles of operation
Wiring diagram for 12/24 volts
12 VOLT DC
24 VOLT DC
FIG. A
FIG. B
NOTE: The 1006 is supplied as a 12 volt
DC unit. For 24 volts DC, see
figure B.
INSTRUCTIONS:
1. Cut the violet and black wires.
2. Splice the violet and black wires
together that are coming out of the
strike. Connect the violet and black
wires together with connector.
3. Individually cap the remaining
two wires coming out of the pigtail.
4. The unit is now 24VDC.
(Wiring methods and materials shall be in
accordance with the National Electric
Code, ANSI/NFPA 70, 1996. This unit
must be powered from a UL listed limited
energy power source.)
RED
VIOLET
BLACK
RED/GREEN
RIB
RED
VIOLET
BLACK
RIB
BLACK
RED/GREEN
VIOLET
©HES 2005
3
4036006.001 rev B
-
Optional LBM/LBSM Wiring Information
(LBM/LBSM ordered separately)
MINIMUM WIRE GAUGE
Solenoid Voltage
REQUIREMENTS
24 VDC
12 VDC
200 feet or less
18 gauge
18 gauge
200 - 300 feet
18 gauge
16 gauge
300 - 400 feet
16 gauge
14 gauge
