18
9.Troubleshooting
9.Troubleshooting
〔
Normal communication does not run
〕
◇
Is the battery used up?
：
Depress the test SW to check if battery check LED lights on.
◇
Are “Radio frequency and ID” different from those of Receiver?
：
Check the Receive for its channel and ID.
◇
Is this machine used outside the radio wave access range?
：
Use this machine within the radio wave access range.
◇
Does the dead point occur?
：
If commutation does no run at a given point, dead point might have
occurred. Change the position of Receiver
（
Layout changing also
allows to change
）
or we recommend you to use the Diversity type
Receiver
（
TW
－＊＊＊
RD
）
.
・・・・・
Contact our sales office for
demonstration equipment.
◇
Is the moving range of wrench lever is out of the movable range of limit
switch during operation of wrench?
：
Verify the Limit switch for its installation.
◇
Is a noise generated?
：
If communication does not run during a given time zone or due to the
operation of the specific device, noise might be generated.
Summary of Contents for TW-510T
Page 2: ......
Page 11: ...5 4 Dimensional drawing 4 Dimensional drawing ...
Page 30: ......
Page 31: ......
