Page | 4
QUICK START GUIDE
STEPS REQUIRED (SEE RELEVANT SECTIONS FOR MORE DETAIL):
1.
Install your WH1 and your R1 receiver(s) in your chosen locations.
(R1 installation instructions packaged with each R1.)
2.
Pair your WH1 and R1(s).
3.
Enjoy the convenience of Herschel’s pre
-set default programme until you can determine the changes you
want
in each location see in the User Guide “Section 8. Setting up a new Heating Schedule”, when you are
ready).
1.
INSTALLING THE WH1
The WH1 is a fixed unit and should be installed in location within your property where it will be convenient to
you to read and adjust the display. Place it out of direct sunlight and at least 1 metre from other electrical
equipment such as radios, TV, Wifi routers, PCs etc. Avoid placing in an area where young children could access
the unit.
The WH1 requires a mains supply and must be mounted onto a recessed cable box or single-
gang “pattress” box
46mm deep (not supplied).
To install the WH1 and connect wiring:
IMPORTANT: Ensure mains power is switched off at the consumer unit.
Release the face plate
Place the unit face down, insert a screwdriver into each of the three clip
locations on the bottom edge of the WH1. Push against the clip and twist
gently to open the cover.
Disconnect ribbon cable & remove face plate
Once the face plate has been gently opened, disconnect the ribbon cable
to release the face plate.
Install wiring
Install mains wiring into the Live, Neutral and Earth clamps clearly
marked on the rear of the WH1. Ensure that there are no exposed wires
or loose connections.
