Installation Guide for Herschel Inspire Units
Assembly Kit
Please check the enclosed assembly kit consists of: 2x fixings brackets, 8x screws, 8x rawlplugs
Step 1
The distance between the two mounting points of each
panel is half the length of the panel. (e.g the 430W panel is
90cm
/ 35.43”
long, so mounting points are 45cm / 17
.71”
apart). Mark these two points on the wall where you want
the heater to be mounted and using the supplied mounting
plates, mark the eight drilling holes on to the intended
installation site.
Step 2
Drill holes in to the installation site on the marked places and
then place the wall plugs in to the drilling holes.
Step 3
To fix the included fixing brackets to the installation site turn
the screws in as far as possible through the grooves of the
fixing brackets in to the wall plugs.
Step 4
Before placing your Herschel far infrared heater panel on to the fixing brackets please check that the four
distance pieces on the rear of the far infrared heater panel are screwed in as far as possible.
Step 5
Now fit the far infrared heater panel on to the two wall
holders.
If ceiling mounting please use the narrower slide-in
channel.
Step 6
Unscrew the four distance pieces on the rear of the far
infrared heater panel so that the panel is fixed securely to
the wall or ceiling and cannot be removed.
Step 7
Please check that your Herschel far infrared heater panel cannot be removed from the wall.
Removal
Screw the four distance pieces so that your Herschel far infrared heater panel can be removed from the fixing
brackets and taken down from the installation site.
PANELS COVERED BY THESE INSTRUCTIONS:
Inspire Comfort Standard White Panels:
IC-400
24“ x 24“ (60 x 60cm)
; 120 & 240V models
IC-750
24“ x 48“ (60 x 120cm)
; 120 & 240V models
IC-1050
24“ x 60“ (60
x 152.4cm); 120 & 240V models
