Select Portable Infrared Panel Heater
The Select Portable Infrared Panel Heater
comes with a factory fitted plug and can be
plugged into an available socket in the room.
Setup
1.
Find the two feet supplied in the
package.
2.
Fit to the long lower side of the heater.
The SMART-R power box at the back of
the panel should be at the bottom edge
of the heater.
3.
Use a screw driver to tighten the friction
screws against the rear surface of the
heater. (Note: tightening the screws
against the front will damage the front
surface of the heater).
The SMART-R receiver allows your Portable
heater to operate in two different ways
according to preference:
•
It will heat to a fixed temperature you set
on the receiver when you switch the
heater on at the wall.
•
It can connect to wifi and be managed via
the SmartLife App.
Controls on the SMART-R receiver are
as
follows:
1.
LED
display
showing
setpoint
temperature
2.
Wifi indicator
3.
Timer On/Off indicator
4.
On / Off button
5.
Manual pairing button
6.
Manual Temperature Increase
7.
Manual Temperature Decrease
8.
Built-in
Thermostat.
Pull
gently
downwards to
sense the temperature
around the heater.
9.
Power Switch (I = On, O = Off)
10. Mains cable.
