background image

IMPORTANT SAFETY PRECAUTIONS

  

READ THESE INSTRUCTIONS CAREFULLY AND RETAIN FOR FUTURE REFERENCE. 

Failure to observe these instructions will invalidate the warranty. 
This unit may be a source of possible shock.  
Disassemble only to replace lamp. No user-serviceable parts inside.  
Source of possible ignition. 

 

 WARNING

 

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY: 

1.

 

Remove the unit from its packaging and check it to ensure it is in good condition before installing and operating. 

 

2.

 

Send the packaging to be recycled. 

DO NOT

 let children play with plastic bags or other parts of the packaging.

 

3.

 

CAUTION: 

Risk of Electric shock

 

a.

 

This  appliance  must  be  disconnected  from  its  power  source  during  installation  or  service  activities  and  when 
replacing.

 

b.

 

DO NOT 

use this heater in the immediate surroundings of a bath, shower or swimming pool or hot tub where it 

could fall into a container full of water.

 

c.

 

Switches and other controls must not be within reach of a person in a bath, pool, hot tub or shower. 

d.

 

DO NOT 

touch this heater or its controls with wet hands.

 

e.

 

DO NOT 

allow power cables to become immersed in water or other liquid.

 

f.

 

DO NOT 

open or try to repair the heater yourself. Servicing should be performed by qualified personnel only.

 

4.

 

In order to avoid overheating and potential fire hazard, 

DO NOT 

cover the heater under any circumstances. If the heater 

should become accidentally covered during  operation, turn it off immediately and clear out any foreign objects that have 
covered the heater or become lodged in the grill. 

5.

 

The unit must be installed with a minimum clearance of 1800mm (71”) to the floor and 300mm (12”) clearance at the top and 

sides of the heater. 

6.

 

DO NOT 

touch the heater when in use. Parts of the heater may exceed 200°C / 392°F during operation. Contact with the 

heater during operation may cause severe burns. Do not touch the heater during or for 10 minutes after operation.  

7.

 

DO  NOT 

use  the heater  if  the  power  cord  is  damaged.  This  must  be  replaced  by  the manufacturer,  its  service  agent  or 

similarly qualified persons in order to avoid a hazard. 

8.

 

DO NOT 

use the heater to ignite materials. 

DO NOT

 operate in locations containing gasoline, flammable liquids or other 

volatile substances. 

9.

 

DO NOT

 install the heater pointing directly downwards. 

10.

 

DO NOT

 install this heater near, or pointing towards flammable objects within 1 metre or where curtains, towels or other 

flammable items can be blown onto the heater. 

11.

 

T

his heater must only be used for the heating of people outdoors or indoors in an unenclosed space. The COLORADO is not 

to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, 
regardless of whether they have been given instruction or are under supervision. Children should be kept away and should 
not be left unsupervised around the unit. 

12.

 

All  operators  shall  only  switch  on/off  the  appliance  provided  that  it  has  been  placed  or  installed  in  its  intended  normal 
operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and 
understand the hazards involved. Children shall not plug in, switch on or regulate the appliance or perform user maintenance 
including cleaning. 

13.

 

DO NOT 

leave the heater operating unattended. 

14.

 

NEVER

 place hands under the heating element during operation. 

15.

 

IMPORTANT:

 Ensure supply voltage does not exceed 245 Volts. 

 
SAVE THESE INSTRUCTIONS.

 

 

WATER INGRESS PROTECTION: 

Herschel COLORADO is rated to a standard IP55.  Suitable for outdoor use. 
 
Installation in potentially wet or humid rooms such as bathrooms must be carried out by a suitably qualified installer and comply 
with local electrical safety requirements. 
 

Summary of Contents for COLORADO 2500






Reviews: