.
The first thing that you need to do is to identify and mark the part numbers on the laser cut parts using the drawings on the
following pages as a guide.
It is possible that several of the laser cut parts may not be completely cut through. If this is the case you can free the part from
the sheet quickly using an X-acto knife.
NOTE: The slight discoloration on the edges of the laser cut parts may be removed by lightly sanding the edges with 400 grit
sandpaper.
Building the Tail Surfaces
1.
Cover the plan with wax paper.
2.
Build the stabilizer using parts S-1, S-2, S-3 and S-4. The remaining structure is made from 3/32" sq. balsa.
3.
Build the rudder using parts R-1, R-2, R-3 and R-4. The remaining structure is made from 3/32" sq. balsa.
4.
Sand the tail surfaces smooth and round the edges. Set the tail surfaces aside until needed later.
