HERO S2650, User Manual

Page: 14 / 23

14
Machine Positioning and Installation
Machine unpacking

Remove the external nylon film from the package

Remove the fastening straps placed around the outside of the packaging box

Remove the packaging box by lifting it above the unit
Pallet removal and machine positioning
Due to its weight, this must be done with the support of a forklift; put the forks under the
base of the machine (be careful to avoid damage to the feet and wheels located under the
machine). Place the machine where it is intended to be used.
The plug is used to disconnect the apparatus from the AC main supply. In final installation
the outlet shall be installed near the equipment and shall be easily accessible.
Instructions for correct positioning
Be certain to respect the following details while positioning the machine:

Place the machine on a steady, horizontal surface by using a level.

The area must be well ventilated.

The surrounding temperature should be kept as constant as possible, around 18°C
(65°F) (and always between 5 and 40 °C [40 and 104°F]).

Make sure the machine is connected only to a wall socket installed according to
regulations, with its grounding circuit and voltage value in compliance with what is
written on the machine’s information plate.
REMOVE ALL PACKAGING AND SHIPPING BRACKETS FROM THE CAN LOADING
AREA !

Adjust the four feet so that the wheels do not touch the floor and so that the
machine is levelled. Once adjusted, secure the feet lock nuts against the base
plate.

Connect the electrical power supply cord, following the safety instructions
previously explained in this manual.
The machine does not have a general on/off switch, so when the power cord is connected,
the shaker is ready to operate.