H
C
Hot
Cold
Hot
Wall under sink
Cold
H
C
Hot
Cold
Hot
Wall under sink
Cold
4
7
Insert the tail of pull-out hose(E) into the
out-put hose(D) and maker sure the auto
lock is locked and you will hear a click if
it does.
8
Install the weight locator(F) around the
upper side of the pull-out hose(E) (as
shown on page1). Make sure it pulls back
when you pull down the spout. This
component is to make sure the spout
goes back better when being pulled out.
But please also NOTE that if you install
the weight locator(F) too close to the
fitting nut(J), the reach will decrease;
9
Turn the main valve on slowly to check if
any connecting part is not fastened to
avoid leaking. Then turn the handle(L)
on to check the waterways. If everything
goes well. the whole installation is
completed.
5
Screw the connection nuts(the female side)
of cold&hot water hoses(K) to your kitchen
water source, fasten with an adjustable
wrench(not included in the package),
usually red for hot water on the left side,
and blue for cold water on the right;
6
Screw the male heads of cold&hot water
hoses(K) to input hoses(C). there are
signs of cold and hot water entrance,
fasten with an adjustable wrench(not
included in the package). Please make
sure that the hot water way goes to the
hot signed input(C), and the cold goes to
the cold signed one;
