Herman Miller Nevi Gaming Desk
Assembly Instructions
20
Step 31. Set-up/Reset the Height-Adjustment System
After installation and connection to
power, the desk’s height-adjustment
system needs to be set-up. In this
state, the table can only be moved
down with reduced speed.
To set-up height-adjustment:
1. Lower the table to its lowest
position using the DOWN button
on the Controller switch (E).
2. Once the desk has stopped
moving, release the DOWN
button briefly.
3. Hold DOWN button again for
15 seconds or until the desk
moves down a further 3-6 mm,
pauses and then moves up
again the 3-6 mm.
4. Release the DOWN button.
Note: If the button is released too
early, the set-up procedure will need
to be repeated. Please follow these
instructions each time the desk is
reconnected to power, following a
fault, or after reconnecting the
drives and the controller.
Control Switch
Lowest position
Raise desk
Lower desk
