3
HermanMiller
Installation Instructions
1BN0MC rev A
FG199 - Wire Manager
1.1 Insert button head screws through holes in wire manager and
into nut plate.
1.2 Position wire manager up to underside of chase extrusion at
desired location. Engage nut plate inside chase groove by fully
inserting button head screw and turning until tight.
FG197 - Cable Management Clip
1.1 Insert cable management clip in chase extrusion as shown.
1.2 To remove cable management clip push on end of clip.
Push to remove
Step 1
Step 1
FG198 - Cable Management Sleeve
1.1 Insert button head screws through holes in Cable
Management Sleeve and into nut plate.
1.2 Position Cable Management Sleeve up to underside of chase
extrusion at desired location. Engage nut plate inside chase
groove by fully inserting button head screw and turning until
tight.
Step 1
