HERKULES G415, Owner'S Manual

Page: 8 / 20

Filling the Gun Washer with Fluid
1)
To clean guns not mentioned here, use the long or short stem
supports as needed [see Fig. 2]. For questions or adapter
2)
kits, contact your paint gun washer distributors.
Preparing the Equipment to be washed
1) Remove paint cup or paint line and the air line from
the paint gun.
2)
Place the long stem support over the short stem support.
3) Remove all gauges and regulators
Place paint inlet of the gun on long stem support. Place the
air cap assembly over the air inlet of the gun to keep
solvent out.
CAUTION
All pressure gauges must be removed before placing the
equipment in the gun washer to avoid damaging the
gauges.
Place the long stem support over the short stem support.
Place paint inlet of gun on long stem support.
4) Remove the air cap/fluid tip from the paint gun (for manual
cleaning only).
Place pots and/or cups on divider platform over front
spray nozzles.
Siphon Feed Guns
Gravity feed Guns (HVLP)
Pressure Feed Guns
Close ball valve located on the bottom of the tank.
Pots and Cups
Placing Equipment in the Gun Washer
evaporating solvent into the tank.
Pour five gallons (18.9 liters) of high quality, slow
Operation
Drain excess paint from cup and gun.
Place the gun siphon tube on the short stem support.
Paint Cup
Long Stem Support
Short Stem Support
Trigger Lock
Air Cap Assembly
Siphon Feed Gun
Fig. 2
Page 8 of 20