03
Extending Mirror:
1. Establish the position for the mirror & mark out the fixing holes.
2. Drill holes to suit & insert wall plugs if required.
3. Screw the fixing plates to the wall, with the back flat to the wall (Fig2).
4. Loosen off the wall bracket grub screws, but do not remove.
5. Place the wall bracket over the fixing plates with the grubs screws at the bottom.
6. Tighten the grub screws until the wall bracket is secure against the wall.
7. Screw the mirror down onto the extending bracket & check for security.
Three Tier Towel Rail:
1. Establish the position for the accessory & mark out the fixing holes, see below for the distance
between fixing brackets.
2. Assemble the shelf using the fixings & hexagonal key provided with the largest tier at the top,
smallest at the bottom (ensure back plate is fitted into the cover plate before fitting tiers). Then
check the position of the marked holes with the shelf prior to drilling.
3. Drill holes & insert wall plugs if required.
4. Screw shelf assembly to the wall & insert screw covering caps
5. Check the shelf for security.
NOTE:
All dimensions refer to the pillar centers. Guide dimensions only, all centres should be
measured & checked prior to drilling.
