hergom E-10 PLUS, Instructions For Installation, Use And Maintenance Manual

Page: 36 / 100

36
2.5
– FLUE PROBLEMS
Below is a list of common problems in all types of stove. All of these problems can be rectified
and sometimes only require slight adjustment for the stove to function normally again.
Remember that the weather affects the functioning of the stove.
If your stove has vapour leaks to the interior of the house, it is most likely that the following
has occurred:
- If the chimney is newly built:
a) The flue is insufficient.
b) The section or height is not correct.
c) There is some obstruction in the unit.
- If it is an existing chimney:
a) The chimney is partially obstructed with soot.
b) An internal or external breakage has occurred producing an air intake.
c) There is a lower section or height than is required by the new appliance.
We recommend reading the chapter titled, INSTALLATION MANUAL, and revising all
the information referring to Chimneys.
6.- TECHNICAL DATA
Specifications of the HERGÓM heater mod. E-10 PLUS.
Maximum heat power transferred 7.5 kW
Accepts logs of the following length: 500 mm.
Door: Height 300 mm.
Width 500 mm.
Fumes ring
150 mm.

Int.
Metal Chimney
150 mm.

Recommended chimney height*. 5 to 6 metres
Brickwork chimney. 150 x 150
Performance 65 %
Mass flow rate of smoke 11 g/sec
Average temperature of smoke; 310 ºC
Temperature exhaust gas ring 316 ºC
Minimum draw recommended: 12.5 Pa
Smoke outlet Vertical
Primary Air Control Manual regulation
Secondary air intake Venturi System
Net weight 92 Kg.
Gross Weight 100 Kg.
(*) In the case of other heights consult your Dealer or the manufacturer (Approximate values)
Recommended fuel:
Fuel Dimensions L x Ø Maximum load per hour E-10-PLUS
Beechwood 40cm x 7cm (approx.) 3 Kg.
Oak 40cm x 7cm (approx.) 3 Kg.
Pine wood 40cm x 7cm (approx.) 3 Kg.
ATTENTION! Your device should not be used as an incinerator and no other types of
fuel should be used (plastic, coal…). Use recommended materials only.
Do not wood washed ashore from the sea as fuel. The salt contained in it will react in the
combustion process and release acid that will damage the iron and steel.