Heras HGD230, User Manual

Page: 59 / 146

EN – Translation of the original user manual - 2.1 | 2019 59
Ill.Nr. Terminal
number
Marking Output function
25 1, 2 Rel1 Flashlight or lamp
25 3, 4 Rel2 Gate state OPEN
25 5, 6 Rel3 Gate state CLOSE
25 4, 5, 6 Rel4 Not used
25 1, 2, 3 Rel5 Not used
The output of Rel1 is switched on at the start of the warning time and
permanently during the movement. The flashing function must be performed by
the connected lamp.
The service engineer can assign one of the following functions to the relays Rel4
and Rel5:
• Lighting (yard lighting) with deactivation relay after a gate movement has
ended
• Traffic light function red/green
•
Maintenance signal (maintenance necessary)
•
Error message
•
JCM No-Touch activation
•
Electro-mechanical brake
•
Safety edge activated
6.4.1 Relay output with 24 V
DC
Control lamps with a 24 volt supply voltage can be connected as follows:
Illustration 31: Electrical connection of 24 VDC relay
Tor zu Tor offen Blinklicht
24V
Rel4 Rel4
Rel3 Rel2 Rel1
in
24V 0V
In5 In6 In7 In8
LB
24V