Heras HGD230, User Manual

Page: 10 / 146

EN – Translation of the original user manual - 2.1 | 2019 10
PRESCRIBED USE / APPLICATION 1.4
Only the correct installation and maintenance by an authorised/qualified company
or person in agreement with the user manual, logbook, checklists and
maintenance lists can ensure the safe operation of the system.
A qualified person is, according to EN 12635, a person who has the required
training, qualified knowledge and practical experience required to install, test and
maintain a sliding gate system correctly and safely.
CONFORMITY WITH EUROPEAN DIRECTIVES 1.5
The installation complies with the following EU Directives/ regulations:
2006/42/ EC Machine Directive
2014/30 EU EMC Directive (electromagnetic
compatibility)
305/2011 EC Construction Product Regulation
The design and production has been executed compliant with the applicable product
standard EN 13241 and the underlying standards EN 12604, EN 12605, EN 12453,
EN 12978 and EN 12635.
A Declaration of Performance (DoP) and Declaration of Conformity (DoC) are
obligatory for this product. The DoP and DoC are included in Appendix B.
The CE mark is located on the rear of the bottom rail of the gate.
DELIVERY 1.6
The gate and the gate drive and control unit must be installed, connected, set up
and tuned by a fitter or an engineer who also connects and programs any
accessories. The gate control unit is adjusted to the options/accessories agreed
with the user. The relevant options are laid down during hand-over.
Of course, you can add optional/accessories afterwards. Contact your supplier for
this.
Gates are always delivered fully tested.