Vibration levels: normal, intense
Autom switch-off: after approx. 60 sec.
Operating conditions: +2 °C - +50 °C, no more than 5 applications in a row, then allow to cool
for 30 min.
Storage conditions: clean and dry
Dimension: approx. 15, 7 x 5, 5 x 7, 9 cm
Weight: approx. 220 g
Accessories: set of 2 brush heads
In accordance with our policy of continual product improvement, we reserve the right for
technical and design changes without notice.
The current version of this instruction manual can be found under
www.hepburnspretty.com.
Insert / replace batteries
Pull the lower part of the device handle down. The waterproof battery compartment
becomes
visible. Insert the two batteries (type AA). Pay attention to the insertion direction (+/-) of the
batteries, as indicated on the battery and inside the battery compartment. Close the battery
compartment again by pushing back the lower part.
Starting up
The Hepburn.S facial cleansing brush comes with 2 brush attachments and 2 protective caps.
Brush head for normal skin
Put the brush head of your choice on the appliance. Use the protective cap to press the brush
head down until it locks into place with an audible “CLICK”.
Use
•
Moisten your skin and the brush head with warm water and place your cleanser on the brush.
•
Bring the prepared brush to your face and turn on the appliance by pressing the ON/OFF
button.
•
The appliance has a “normal” vibration level and an
“
intense” vibration level. The appliance is
set to the
“
normal” vibration level at the factory. Start with this lower level of speed and a gentle
cleanser.
•
Move the vibrating brush in small circular motions over the area of skin to be treated. Make
sure that the brush is flush to the skin but not pressing too strongly on it.
•
To get to the fast vibration level or to switch between the different vibration levels, briefly
press the vibration button while the appliance is running.
•
The appliance is programmed with a recommended usage time of 1 minute. Do not treat any
skin area longer than 20 sec. (see fig.: forehead 20 sec., each cheek 10 sec., nose and chin region
20 sec.).
•
The timer signals with a short pause that it is time to change the brush position on the face.
Apply the brush to the next area of skin to be treated. Once the minute has elapsed, the