4
These models include adjustable blower speed control for (2) levels of operation – Hi, and Low. The switch is located on
the printed circuit board inside the dryer as shown in Fig. 1 below.
Note: The factory setting for the blower speed control is “Hi”.
To adjust blower speed:
1. Disconnect the power source.
2. Use the security hex key supplied to turn the cover mounting screws
clockwise
to remove the cover from the dryer.
3. Locate the switch on the printed circuit board inside the dryer as shown in Fig. 1 below, and adjust blower speed as
desired. (Note: When Low speed is selected, LED 4 on the printed circuit board will light “blue”).
Reassemble the dryer cover using the security hex key supplied to turn the cover mounting screws
c
ounter-
clockwise
and tighten until snug. Do not over tighten.
4. Reconnect the power source.
Adjusting Blower Speed
Low Speed
Hi Speed
Disgnostic
LED’s
Speed Switch
Figure 1
7
1
1
2
4
5
6
9
8
3
distributed by
RESTROOM DIRECT 704 . 937. 2673
www.
RestroomDirect
.com
