6)
Setup the Conference Mode
When the lock is in Conference Mode, once it is opened by a finger, it will be unlocked all the time and you have to put a finger to lock it.
To setup the Conference Mode, do the following:
6.1
Put the master finger, it will emit a sound ¡Di¡ ¡..
6.2
Press the Don¡t Disturb button, the green and red lights will flash. The lock goes to Conference Mode.
Do the same to switch back to normal mode.
7)
Setting Electronic Key
Electronic Key is specially equipped to this lock for opening the door at emergency or backup power supply. It is a top priority key to open
the lock. It should be well kept after being set. Up to 5 electronic keys can be equipped for each lock.
7.1
Add Electronic Key
A. Insert the Mini USB Port of the Electronic Key into the lock.
B. Press corresponding button on the PCB
(
See attached picture
)
Electronic Key, Release the button when Red light flash.
C. Press
the button of Electronic Key and the red light turns off. Release the button the press the button again in 5 seconds and then the
Red light flashes and turns off. Electronic Key is added successfully.
7.2
Delete Electronic Key
A. Insert the Mini USB Port of the Electronic Key into the lock.
B. Press corresponding button on the PCB
(
See attached picture
)
Electronic Key, Release the button when Red light flash.
C. Press
the button of Electronic Key and the red light turns off. Then pull the Electronic Key out, the Electronic Key is deleted successfully
.
7.3
Delete All Electronic Key
A. Insert the Mini USB Port of the Electronic Key into the lock.
B. Press corresponding button on the PCB
(
See attached picture
)
Electronic Key, Release the button when Red light flash. Press the button
while the red light is on until the light turns off. Then all Electronic Keys are deleted successfully
.
1.
Insert Electronic Key
2.
Coding the Electronic Key
3.
Open the door with Electronic Key
8)
Open the door with Fingerprint
Press one finger on the sensor window, the Red light turns on. If the fingerprint is authorized, it emits a sound ¡Di---¡ and the Red light turns off
and Green light flashes one time. And the door can be opened. If the fingerprint is not authorized, then it emits two sounds a sound ¡Di---¡.
Note: press the finger forcibly; try to fill the window with fingerprint. It may not recognize the fingerprint properly when the finger is too dry, you
can huff to your finger.
Put
the
master
finger
Press
DEL
Put
master
finger
two
times
Put
the
master
finger
Press
the
Don¡t
Disturb button
