Hensel TRIA 3000 AS, User Manual, Page: 28 / 46

User manual // Tria AS Power Pack
28
HENSEL-VISIT International GmbH
3 General safety regulations
Power packs store electrical energy in capacitors by applying
high voltages. These form a source of danger, which must be
carefully excluded.
Besides general rules on handling electrical appliances, the
following safety measures must be observed. Therefore read
and comply the safety hints (also see the paragraph Starting
up) within the user manual
before turning the appliance on.
The present power pack is meant for studio use of pro-
fessional photographers. Its task is to provide electrical
energy for certain fixed types of HENSEL flash lamps.
The appliance must not be used for any other purpose than
that described above, especially not for other electrical
appliances.
Contact with the capacitor voltage is perilous. Thus
opening of the housing of Tria AS power pack and repairs
must only be made by authorized customer service.

Flash tubes must only be exchanged by authorized trained
personnel. Exchange of flash tube and modeling lamp
must only be performed with the appliance turned off,
unplugged from the mains and discharged.

Power packs must only be used on supply lines (mains)
with working protective conductor (earth line).

Only lamp connectors with immaculate contacts must be
used, burned or corroded contacts may cause burstings in
the area of connectors and lamp sockets.

Do not route cables across the studio floor if possible, so
that damage is excluded. If routing across the studio floor
cannot be omitted, then it must be ensured that vehicles,
ladders, etc do not damage cables. Damaged cables and
cases must be replaced immediately by customer service.
Proper use
Improper use