Hensel Tria 24 S, User Manual, Page: 36 / 42

User manual // Tria 24 S / 24 SF Power Pack
36
HENSEL-VISIT GmbH & Co. KG
Flash readiness
Flash readiness of the power pack is shown by

READY control lamp 11 turned on (green light)

Modeling lamp turned on when Flash Check mode is
activated (switch
5 )

an acoustical signal, when AUDIO 6 is switched on.
APD system
In case of reducing the flash power, the stored energy will be
discharged by APD system (Automatic Power Drop). No flash
will be triggered. After switching off, the power pack will be
automatically discharged.
Modeling lamp
The modeling light can be toggled between the following
positions: OFF / FULL PROP by pressing the LAMP switch
10. The control LED indicates ON / OFF position. To activate
the modeling light, the lamp switch of the flash head (or the
main switch) must be switched on.
FULL
When FULL mode is selected, the maximum output of the
modeling lamp is achieved independently from the flash
output setting.
PROP
To have proportionality between modeling lamp and flash
power output, the PROP mode must be selected. When the
maximum flash power output is reduced, the maximum
modeling lamp output is proportionally dimmed.
Dim mode
The dim mode is intended to prolong the life span of the
modeling lamp. If the modeling lamp level is adjusted to FULL
or to PROP between 10.0 and 9.1, the output is automatically
dimmed by approximately 1 f-stop after having stopped work-
ing with the flash unit for longer than 35 minutes (default
value). Pressing any button you like switches the modeling
light to the previously adjusted undimmed level. If required,
this default value can be changed by entering a value from 5
minutes up to 95 minutes.
READY
FC
AUDIO
10:
LAMP