Hensel Porty Premium Plus, User Manual

Page: 30 / 50

User manual // Porty Premium Plus
30
HENSEL-VISIT International GmbH
3 General safety regulations
Power packs store electrical energy in capacitors by applying
high voltages. These form a source of danger, which must be
excluded carefully. Besides general rules on handling
electrical appliances, the following safety measures must be
observed. Therefore read and comply the safety hints (also
see the paragraph
Starting up ) within the user manual before
turning the appliance on.
The present power pack is meant for studio use of
professional photographers. Its task is to provide electrical
energy for certain fixed types of HENSEL flash lamps.
The HENSEL Radio Flash Trigger and Power Control
System Strobe Wizard Plus is used for triggering flashes
and adjusting the flash power of specially HENSEL flash
units with built-in receiver via radio signal.
Power pack and radio control unit may not be used for any
other purposes than that described above, especially not for
other electrical appliances.
Contact with the capacitor voltage is perilous and
therefore opening of the case of Porty power pack and
repairs may only be made by authorized customer
service.

Flash tubes must only be exchanged by authorized trained
personal. Exchange of flash tube and modeling lamp must
only be performed with the appliance turned off, unplugged
from the mains and discharged.

Only lamp connectors with immaculate contacts must be
used, burned or corroded contacts may cause burstings in
the area of connectors and lamp sockets.

Do not route cables across the studio floor if possible, so that
damage is excluded. If routing across the studio floor cannot
be omitted, then it must be ensured that vehicles, ladders, etc
do not damage cables. Damaged cables and cases must be
replaced immediately by customer service.
Proper use
Improper use