Mounting and removing components of
the device
30
Installing and removing the protection glass
WARNING
Heat is generated during the operation of the device.
Touching the device at the front can lead to severe burns.
Always let the device cool down for 5 to 10 minutes
before mounting or removing components.
To install the protection glass (1), proceed as follows:
Wear gloves according to EN 407.
Tilt the protection glass (1) slightly and insert it into one of the three
springs (2).
Insert the protection glass (1) into the second spring (2) using slight
pressure.
Press the protection glass (1) into the third spring (2) until it engages
securely.
To remove the protection glass (1), proceed as follows:
Tilt the protection glass (1) slightly and so that it disengages from two of
the three springs (2) one after the other.
Release the protection glass (1) from the third spring (2) by pulling it
slightly and remove it.
