Henny Penny Wendy's Evolution Elite EEG-251, Operator'S Manual

Page: 84 / 90

Troubleshooting
70
Problem Cause Correction
Bubbles in
oil during
entire filter-
ing
process. Filter pan not
completely
engaged. Make sure filter pan return line is pushed completely into
the receiver on the fryer.
Filter pan
clogged. Clean pan and change paper or pad.
Damaged O-ring
on filter line re-
ceiver on fryer.
Replace O-ring.
Filter motor
will not run. Power cord for
vat #1 is not
plugged in. Plug power cord into receptacle.
Open circuit. Breakers in fryer tripped; open left door and reset breaker
on fryer.
Thermal reset
button on the rear
of the pump mo-
tor is tripped. Allow motor to cool, then, using a screwdriver, press hard
against the button until it clicks.
T To o p prre evve en ntt b bu urrn nss cca au usse ed d b byy ssp plla assh hiin ng g
ssh ho orrtte en niin ng g,, ttu urrn n tth he e u un niitt’’ss p po ow we err ssw wiittcch h tto o tth he e o offff
p po ossiittiio on n b be effo orre e rre esse ettttiin ng g tth he e ffiilltte err p pu um mp p m mo otto orr’’ss
m ma an nu ua all rre esse ett p prro otte eccttiio on n d de evviicce e..
7 7..2 2 E Errrro orr C Co od de ess
In the event of a control system failure, the digital display shows an error message.
The message codes are shown in the display column below. A constant tone is heard
when an error code is displayed, and to silence this tone, press any button.
T Ta ab blle e 7 7--2 2 E Errrro orr C Co od de ess
Display Cause Panel Board Correction
“E-4” Control board
overheating. Turn switch to off position, then turn switch back to on; if
display shows “E-4”, the control board is getting too hot;
check the louvers on each side of the unit for obstruction.
“E-5” Oil overheating. Turn switch to off position, then back to on; if display
shows “E-5”, the heating circuits and temperature probe
should be checked.
“E-6A” Temperature
probe open. Turn switch to off position, then back to on; if the display
shows “E-6”, the temperature probe should be checked.
“E-6B” Temperature
probe shorted.
“E-10” High limit. Let the unit cool down (15-20 minutes), push up on metal
reset button under right side of the controls; if high limit
does not reset, high limit must be replaced.