Henny Penny Wendy's Evolution Elite EEG-251, Operator'S Manual

Page: 83 / 90

Troubleshooting
69
C Ch ha ap ptte err 7 7 T Trro ou ub blle essh ho oo ottiin ng g
7 7..1 1 T Trro ou ub blle essh ho oo ottiin ng g G Gu uiid de e
T Ta ab blle e 7 7--1 1 T Trro ou ub blle essh ho oo ottiin ng g
Problem Cause Correction
Power
switch on
but fryer
completely
inoperative. Open circuit.
• Plug fryer in.
• Check breaker or fuse at supply box.
Control er-
ror code
“E-10” Oil temperature
too high. Let unit cool down (15-20 minutes). push up on metal re-
set button under right side of the controls; if high limit does
not reset, high limit must be replaced.
Vat is
under-
filled. BIB is low or
empty. Fill the BIB.
BIB oil line is
clogged or
collapsed. Check BIB line.
Filter pan needs
cleaned. Clean filter pan and change paper or pad.
Oil foaming
or boiling
over top of
vat. Water in oil. Drain and clean oil.
Improper or bad
oil. Use recommended oil.
Improper filtering. Refer to filtering procedures.
Improper rinsing
after cleaning the
vat. Clean and rinse vat and then dry thoroughly.
Oil will not
drain from
vat. Drain valve
clogged with
crumbs. Open valve, force cleaning brush through drain.
Drain trough
clogged. Remove right side panel and remove plug from end of
trough, clean trough.
Filter motor
runs but
pumps oil
slowly. Filter line connec-
tions loose. Tighten all filter line connections.
Filter paper or
pad clogged. Change filter paper or pad.
Filter not reas-
sembled
correctly. Refer to assembly instruction on inside door.