Henny Penny Velocity OXE-100, Operation Manuals

Page: 105 / 118

Zigbee
Radio
93
Ensure seamless data communication between the Digi radio and control board by doing the
following:
1 10 0..3 3..3 3..2 2..1 1 C Ch he ecckk tth he e W Wiirre ess
Verify the 9-pin connector is connected correctly, and not reversed. See Figure 10-1 Connecting
Wires to Terminal Block, page 79
and also Figure 10-5
Connecting 9-Pin Connector, page 82
. Also,
refer to . If correctly wired, continue to 10.3.3.2.2 Check Data Communication, page 93 . If incorrectly
wired, repair and verify seamless data communication.
1 10 0..3 3..3 3..2 2..2 2 C Ch he ecckk D Da atta a C Co om mm mu un niicca attiio on n
If the Digi radio hardware is installed and operating correctly, verify the fryer’s control board
(software) is communicating with the Digi radio. Refer to
10.2.2 Configure the OPS/QPM Settings,
page 83 .
- If SP-4 O OP PS S//Q QP PM M E En na ab blle ed d is set to Y YE ES S the control board monitors the RS-485 data link for
messages from a ZigBee radio module and responds appropriately when requests are received.
Continue at
10.3.3.2.3
Join or Re-Join the Network, page 93
.
- If SP-4 O OP PS S//Q QP PM M E En na ab blle ed d is set to N NO Othe control board does not attempt to communicate with
the radio module (via RS-485). All ZigBee related information (displays) indicates OPS/QPM is -OFF-
.
Set O
OP PS S//Q QP PM M E En na ab blle ed d to Y YE ES S and then continue at 10.3.3.2.3 Join or Re-Join the Network, page
93 .
IIN NF FO O: Setting “OPS/QPM System Enabled?” to “NO” does not actually disable the radio module or
prevent it from communicating with the ZigBee network. It simply configures the fryer’s control board
software to ignore the radio module and ignore all things related to OPS/QPM (i.e. batch size
requests, etc.). The radio module can talk to the wireless network; however, the control board
(software) will not respond to the radio.
1 10 0..3 3..3 3..2 2..3 3 JJo oiin n o orr R Re e--JJo oiin n tth he e N Ne ettw wo orrkk
Complete the steps in section 10.2.2.3 Verify Communication, page 86 and ensure the fryer’s Digi
radio is Joined to the OPS/QPM network. Continue diagnostic steps as necessary by referring to
10.3.4
ZigBee Radio Info Display, page 93
.
1 10 0..3 3..4 4 Z Ziig gB Be ee e R Ra ad diio o IIn nffo o D Diissp plla ayy
Use the information obtained from the ZigBee radio information display to further diagnose technical
issues.
1 10 0..3 3..4 4..1 1 A Acccce essss tth he e D Diissp plla ayy
Access Info Display by doing the following:
1 1))
Press the Menu and Info buttons together at the same time. Release the buttons once = == =
IIN NF FO O M MO OD DE E = == = displays.
2 2))
Press the left-arrow button once. The OPS/QPM RADIO screen displays.