Intelligence Aided Lifting Equipment
43
set position layer. If you need to continue to operate the equipment to the upper level or the lower
level, you need to operate the handle to the zero position
2
first, and then conduct the up or down
movement to lift the equipment to the next layer, and which would automatically cease movement.
Operate the equipment in turn, so as to achieve precise stop of the equipment at each layer.
Note:
Spacing between adjacent stops must be greater than 20 mm.
5.7.1
Signal setting
The palletizing
signal can be input through interfaces on the host extension board, handle
extension board, or expansion board. Set the corresponding IO number in “Extended Function
Settings”
→
“Extended Interface Settings”
→
“Palletizing
Signal Input”.
For example:
Take Pin 11 of the coaxial handle extension interface as the palletizing
signal
input terminal. Connect Pin 12 and Pin 6 of the handle extension interface to the normally open
contacts of the switch (self-locking/self-recovery), and then set the IO number to 12 in "Palletizing
Signal Input”; when the switch contact is on, the palletizing signal input has a signal, and the
palletizing function is valid; when the switch contact is open, the palletizing signal input has no
signal, and the palletizing function is invalid.
5.7.2
Operation steps
1.
Turn on the input switch contact of the external palletizing signal; (The layer setting can
be completed first, then the signal settings to facilitate the layer height setting).
2.
Enter the palletizing function setting → turn “On” the palletizing function switch;
3.
The operating equipment is raised to the position of the required setting layer;
4.
Click on the “ENT” button in the “Palletizing Function Setting” → “Layer 1” to save the
settings, with a maximum of 20 layers.
(Layer reset: Enter the layer number to be reset, and then press the "DOWN/UP" button
to switch the display to "Invalid" interface and press the "ESC" button to exit, which
means that the reset of the layer has been finished. You may also reset the entire layers
by setting menu of "Layer Height Reset")
5.
When the operating handle moves up or down to the adjacent layer, it stops
automatically;
6.
The operating handle is returned to the zero position and then moved up or down to the
next layer;
2
Zero position: When the coaxial slide handle (remote mounting slide handle) in the slide handle is not under force;
when the stepless shift handle is not pressing on the UP / DOWN keys;
