875-0422-10 Vector VR1000 QRG Rev A1
March 29, 2019
Page
20
of
36
Configuring the VR1000 Using the WebUI
,
Continued
Heading menu
,
continued
Table 5 lists the heading configurations.
Table 5: Heading Configurations
Heading
Configuration
Description
Heading Bias
Add a bias to the heading value the receiver
outputs.
Heading is defined as the direction of the
vector created from the primary to secondary
antenna. Heading is measured using true
north.
Range: -180 – +180
Pitch Bias
Add a bias to the pitch value the receiver
outputs.
If the receiver is in “roll” mode, this will add a
bias to the roll instead.
Range: -15 – +15
Gyro Aiding
Gyro aiding enables the use of the internal gyro
sensor and allows for the continuous output of
heading for up to three minutes during a GNSS
outage. Gyro aiding improves the reacquisition
time when GNSS heading is lost because of an
obstruction in GNSS signal.
Negative Tilt
Change the sign of the pitch/roll measurement.
Tilt Aiding
Turn OFF or ON tilt aiding. When on, the
sensors are used to reduce the RTK search
volume – improving heading startup and
reacquisition times.
Flip Board
N/A
Level
Operation
If the Vector will be operated /- 10
degrees of level, you may use this mode of
operation for increased robustness and faster
acquisition times of the heading solution.
Continued on next page
