Hemisphere GPS Crescent A100, User Manual, Page: 14 / 44

Crescent A100 User Guide
7
Extension Power/Data Cable
The Crescent A100 system is quickly installed with one of the various
extension cables. The location of the extension cable should be made
with the following requirements in mind:
• Power leads at the “Y” end must reach a power source.
• The data connector communication port must reach to connect
to a data storage device or guidance system.
When choosing a route for the Crescent A100 extension cable:
• Avoid running cables in areas of excessive heat
• Keep cables away from corrosive chemicals
• Do not run the extension cable through door or window jams
• Keep the cables away from rotating machinery
• Do not bend excessively or crimp the cables
• Avoid placing tension on the cables
• Remove unwanted slack from the extension cable at the
receiver end
• Secure along the cable route using plastic wraps
Crescent A100 Placement
Placement of the Crescent A100 is crucial to the system’s operation. The
GPS engine inside the Crescent A100 computes a position based upon
measurements from each satellite to the internal GPS antenna unit.
Mount the Crescent A100 on your point of interest. When choosing a
Warning:
Improperly installed cables near machinery can be dangerous.
875-0163-000 (Crescent A100).book Page 7 Tuesday, November 13, 2007 11:29 AM