Vent the PClamp. The PClamp will centre itself automatically on the round rod.
Here, the PClamp should be as close to its final position as possible but sufficiently free
so that it can align itself.
Tighten the fastening screws crosswise over several circuits up to the defined
tightening torque, please also refer to the installation instruction on Page 10. Open and
close the PClamp several times between each step. The screws may only be tightened
when the PClamp is closed and thus centred
Do not exceed the recommended tightening torque (see Page 10), use bolt adhesive.
Check the screw connections in regard to the occurring loads. HEMA assumes no
warranty for this.
Apply nominal pressure to the PClamp and check for ease of movement. If necessary,
repeat the installation process.
PClamp N
EN
12
PClamp_EN_2020_22012020 23.01.2020 15:39 Seite 12
