HTMA TOUCH Series
6 Zones Mixer Amplifier with Timer, USB, SD, BT, Tuner
10
9. 100V Auxiliary Output terminals
- This output allows the user to connect
100V speakers. It is not controlled by 6-Zone buttons. It can be very useful,
for instance, if, in addition to the 6 zone 100V speaker lines, you also need a
local monitor and need to hear all schedules play lists no matter what zones
are active. In this case you can use this output for this purpose.
WARNING: Pay attention to polarity when connect speakers to the
unit. Each output has positive terminal (+), and negative terminal (-).
10. MIC3 Input Jack
- Connect here microphones of unbalanced 600 ohm with
1/4″phone plug (6,3mm).
11. MIC2 Input Jack
- Connect here microphones of unbalanced 600 ohm with
1/4″phone plug (6,3mm).
12. MIC3 Volume
- This knob adjusts Mic3 level.
13. MIC2 Volume
- This knob adjusts Mic2 level.
14. BT Antenna
- Connect here the supplied BT antenna.
5. MICROPHONE USE
1.
Turn MIC volume down before plugging the microphone (knob n.8 on front
panel).
2.
Plug the 6.3mm connector int MIC jack (n.9 on front panel). Adjust Master
Volume (knob n.13 on front panel) and then turn gradually MIC volume so
that Output Level LED 8 and 10 occasionally lit (n.10 on front panel).
NOTE: MIC input has priority on other sound sources. This function is
helpful for enforcing an emergency broadcast or paging messages.
6. EXTERNAL AUDIO SOURCE
When you need to use other external sources (such as an external CD, DAB radio,
DVD, Tablets, etc.), connect any line-level audio sources to the stereo AUX input
(n.3 on rear panel). Adjust Master Volume (knob n.13 on front panel) and then
turn the AUX Volume knob (n.7 on front panel) to reach the appropriate volume,
so that Output Level LED 8 and 10 occasionally lit (n.10 on front panel).