2
SA-IR-PROG
Data is subject to change without notice. More information at: www.helvar.com
T13 142 1A 07.11.2011 2/2
Programming
Preset
functions
0
1
2
3
UHS5 Handset Graphics
Description
Button Activation
On / Raise
On
Raise
Turn lights on or to raise lights.
Off / Lower
Off
Low er
Turn lights off or to lower lights.
Walk test
On
Off
When set to On this causes a red LED to flash on the sensor
when it detects mov ement. Use this f eature to check f or
adequate sensitiv ity lev els.
Time Out
(Time
adjustment)
1, 10 &
20
minutes
5, 15 &
30
minutes
10
seconds
Once the detector is turned on, this v alue sets how long the
lights will stay on once mov ement has ceased.
Lux on
level
(Switch
level on)
2, 5 & 7
4, 6 & 9
Lux lev el setting to prev ent the luminaires being switched on if
the ambient light lev el is sufficient (adjustable between 1
and 9). The luminaires will alway s be switched on at lev el 9.
Light Level
2 (200)
5 (500)
7 (700)
4 (400)
6 (600)
9 (900)
Sets a target light lev el to be maintained by the lighting system.
Lux off
level
(Switch
level off)
2, 5 & 7
4, 6 & 9
Lux lev el setting to switch the luminaires off during occupancy if
the ambient light lev el goes abov e the setting (adjustable
between 1 and 9). Lev el 9 will alway s keep the lights on. This
setting can be used for “window row switching”.
Sensitivity
1, 5 & 9
3, 6 & 8
Sensitiv ity lev el f or detecting mov ement.
1 = low sensitiv ity
9 = high sensitiv ity
Defaults
D
Returns the unit to the def ault settings.
Burn-in
0
50
100
Determines how long the output will be at 100% so that lamps
‘burn-in’. The ’burn-in’ time is not aff ected by power supply
interruptions.
Presence /
Absence
Presence Absence
Presence mode allows the output to turn on when mov ement is
detected and off when mov ement ceases. Absence mode
allows the output to turn off when mov ement ceases, but must
be manually turned on f irst.
Preset PRS
A
B
2 presets f or Presence mode.
See Product Guide for device to
be programmed
Preset ABS
A
B
2 presets f or Absence mode.
See Product Guide for device to
be programmed
Shift
Use this button to select the settings in red and blue signif ied
by the ‘Shif t 1’ and ‘Shift 2’ LEDs
Number of Shift key presses
SHIFT 1 SHIFT 2
SHIFT 1 SHIFT 2
SHIFT 1 SHIFT 2
SHIFT 1 SHIFT 2
Programmer Graphics
