1
SA-IR-PROG
Data is subject to change without notice. More information at: www.helvar.com
µDim IR Programmer
The SA-IR-PROG is a compact infrared handset used for the
programming of µDim sensors.
Pointing the Handset
You must point the handset directly at the device that you want
to control or program .
When programming a device it is only necessary to point the
handset when ‘sending’ a new setting.
Sending settings to a device
To send the programming parameters to the device follow the
table on page 2. The shift key is used to access the parameters
in red and blue text. The Send LED flashes once to signify that
a setting has been sent.
Important note
This handset may include settings that are not used on the
device being programmed. Refer the individual device’s Product
Guide for default and special settings.
T13 142 1A 07.11.2011 1/2
Technical specifications
•
Dimensions
86 mm x 4 mm x 67 mm
•
Weight
0.017 kg
•
Battery
3 Vdc lithium battery
CR2025 (supplied with unit)
•
IR range
7m
•
Temperature
0ºC to 35ºC
•
Humidity
5 to 95% non-condensing
•
Compliance
EMC-2004/108/EC
Care and maintenance
Replacing the Battery
The battery compartment is located on the bottom edge of the handset.
Release the retaining lug (Fig 1.1) to allow the battery holder to be slid
out (Fig 1.2).
Lift out the battery from the holder and insert a replacement battery
(type CR2025 or equivalent), ensuring correct polarity.
Slide the holder back into the handset, ensuring that the retaining lug
clicks into place.
The exterior of the handset can be cleaned by using a damp cloth.
Stubborn marks may be removed by using a mild detergent.
Fig 1: Accessing the internal battery
