ELECTRIC SAUNA HEATER
1105
– 901
1105
– 1051
1105
– 1201
1105
– 1501
CONTROL PANEL
1410
– 33 – 1517
1410
– 33 – 1517 – 3
1410
– 33 – 1519
1601
– 12
1601
– 13
2005
– 6
CONTACTOR BOX
2005
– 4
IMPLEMENTATION
Before installing and using the sauna heater, please check the following:
•
Make sure you have received all the necessary equipment: sauna heater, control centre, sensor.
•
Make sure the voltage of the sauna heater and the control centre is correct and the control centre matches the
sauna heater.
•
Make sure the output of the sauna heater matches the volume of your sauna. The volumes presented in Table 1
must be adhered to.
•
Refer to the installation measurements given in Image 1. The specified measurements must be adhered to. Any
deviation causes a fire hazard.
•
Read these instructions for use and installation carefully.
•
Before taking a sauna bath, make sure the sauna room is suitable for taking a sauna bath.
•
Before setting remote control mode, make sure the sauna room is suitable for taking a sauna bath.
Persons with reduced physical and mental capacity, sensory handicap, or little experience and knowledge about how the
device is operated (e.g. children), should only operate the device while supervised or according to instructions given by the
persons in charge of their safety.
Make sure that children do not play with the sauna heater.
SELECTION OF SAUNA HEATER OUTPUT
The output of sauna heater is determined in accordance with the volume of the sauna room as specified in the Table below.
The values given apply for a well insulated sauna. If the sauna has unclad walls made of tile or concrete, add approximately
1.5m
3
for each m
2
of tile or concrete wall. The sauna heater output is then determined according to the total volume. Any
timber walls should also be insulated.
7013916 SKLE 41 H
Laava
Skle
Instructions for use and installation LAAVA
and
SKLE
REWARD YOURSELF
