Quick Start Guide REX 100 WAN|WiFi
21
9. Description of LEDs and buttons
9.1 LED display
PWR
Indicator light for the power supply
RDY
Readiness indicator
(this LED must show a solid light after a max. of 110 s)
CON
Off:
There is no active Internet or VPN connection
Solid light:
Internet connection active or possible, but VPN connection
inactive
Rapid flashing (3 Hz):
The router is attempting to establish a VPN connection
Flashing (1.5 Hz):
VPN connection is active
USR
Solid light:
When loading default settings, firmware files, or device configu
-
rations
Flashing (1.5 Hz):
A portal configuration was recognized on the USB stick
(see FCN button, chapter 9.2.)
Rapid flashing (3 Hz):
A firmware file was recognized on the USB stick (see
FCN button, chapter 9.2.)
9.2
Button functions
FCN
1. Function button used to manually establish a connection with the
portal server (see screenshot on page 7, chapter 4.3)
Interfaces
Internet
“Connect to server on“)
2. If the USR LED starts flashing, this means that you have ten seconds to
press this button in order to load data from an inserted USB stick.
RST
Reset button for restarting the router
10. Restoring the REX 100 router to its default settings
In order to reset the REX 100 to the factory settings, the following steps are neces
-
sary:
-
Apply a supply voltage (or press “RST”) until the PWR LED lights up.
-
Wait until the RDY LED flashes.
-
Press the FCN button for approx. 10–15 seconds until the USR LED flashes orange.
-
After you release the FCN key, the REX 100 reboots and once again has the factory
settings
Important:
The IP address of the REX 100 LAN interface is reset to 192.168.0.100/24.
