Helmholz 700-862-WAL01, Quick Start Manual, Page: 20 / 22

Quickstart Guide WALL IE /WALL IE PLUS | Version 15 | 25.08.2022 20
10 LEDs status information
10.1.1 WALL IE (700-860-WAL01)
PWR
Off No power supply or device defective
On Device is correctly supplied with voltage
RDY
On Device is ready to operate
ACT
Flashing or on Permitted data transfer between WAN and LAN
USR
Flashing light Reset to works setting activated
RJ45 LEDs
Green (Link) Connected
Orange (Act) Data transfer at the port
10.1.2 WALL IE PLUS (700-862-WAL01)
PWR
Off No power supply or device defective
On Device is correctly supplied with voltage
RDY
On Device is ready to operate
ACT
Flashing or on Permitted data transfer between WAN and LAN
USR
Flashing Reset to works setting activated
LEDs at
RJ45 Ports
Orange Port is assigned to the WAN network
Green Port is assigned to the LAN network
Green (Link) flashing Connected with 100 Mbps
RJ45 LEDs
Green (Link) on Connected with 1000 Mbps
Orange (Act) Data transfer at the port
11 Function of the buttons
The " FCN " button can be used to reset the WALL IE to factory
settings . The " FCN " button must be held down during the start-
up phase of the WALL IE. The successful resetting of the
parameters and settings is acknowledged by the "USR" LED
lighting up during the boot process. The "
FCN " button can then
be released.
The " RST " button triggers an immediate restart of the WALL IE in which all saved settings are retained.