TABLE OF CONTENTS
SOFTWARE SETUP
Pronterface............................................................................................................................................2
Cura 15.04..............................................................................................................................................3
BED CALIBRATION
Using Pronterface................................................................................................................................11
Using LCD ...........................................................................................................................................13
LOAD/UNLOAD FILAMENT
Using LCD (extruder 0 only).................................................................................................................14
Using PRONTERFACE..........................................................................................................................15
FIRST PRINT
Cura and SDCard..................................................................................................................................16
Pronterface and USB Cable..................................................................................................................16
GETTING STARTED WITH DUAL EXTRUSION
How to setup the offset of the extruders............................................................................................17
Set up the two extruders with the same height..................................................................................19
Steps to print with two extruders........................................................................................................21
The information on this manual was written with software running on Microsoft Windows 8.1
but the same software can be found for MAC and Linux and the same instructions may work
on other operating systems.
V7_20160126
