5
• Before each cycle of operation, the operator shall perform the pre-operation checks
specified in this manual or by the manufacturer, including:
• That all guards and pads originally supplied by the manufacturer are in proper place
and in serviceable condition;
• That the area that the unit is to be operated in is safe and suitable for safe
operation;
• That the braking system is functioning properly;
• That all safety labels are in place and understood by everyone, including the rider;
• That any and all axle guards, chain guards, or other covers or guards supplied by
the manufacturer are in place and in serviceable condition; and
• That tires/wheels are in good condition, inflated properly (if applicable), and have
sufficient tread remaining.
• Operators/riders shall adhere to all manufacturer’s recommendations and
instructions, as well as comply with all laws and ordinances, including:
• Units without headlights shall be operated only with adequate daylight conditions of
visibility, and
• Owners/riders should highlight and make the scooter conspicuous, including the
use of lighting, reflectors, and for low-riding units, signal flags on flexible poles.
• Persons with the following conditions shall be cautioned not to operate the scooter:
• Those with heart conditions;
• Pregnant women;
• Persons with head, back, or neck ailments, or prior surgeries to those areas of the
body; and
• Persons with any mental or physical conditions that may make them susceptible
to injury or impair their physical dexterity or mental capabilities to recognize,
understand, and perform all of the safety instructions and to be able to assume the
hazards inherent in the use of the scooter.
• Operators/riders always shall use appropriate protective clothing, including but
not limited to a helmet, with appropriate certification, and any other equipment
recommended by the manufacturer.
• Avoid sharp bumps, drainage grates, and sudden surface changes.
Note:
Metal and electrical conductors should not be allowed to contact the charging
port, as doing so will result in a short circuit.
PRE-RIDE SAFETY CHECKLIST
• Check to make sure that the brake system is functioning properly.
• Check to make sure that all components are properly secured and are functioning
according to the manufacturer’s specifications.
• Components must be maintained and repaired and only with the manufacturer’s
authorized replacement parts. Installation should be performed only by
qualified personnel.
