11
3. Insert the tab on the lock washer into
the hole on the front fork and tighten the
nuts using two 15mm wrenches.
WARNING
Make sure that once
the nuts have been tightened, the tabs
on the lock washers are securely in the
corresponding holes on the front fork.
Inflating the Tires
Tires are inflated before shipping, but they
invariably lose some pressure between
the point of manufacturing and your
purchase.
Using a bicycle style tire pump for a
Schrader valve, inflate the tires to the PSI
indicated on the sidewall of the tires.
CAUTION
Use of pressurized air supplies such as those found at service
stations is not recommended and if not used properly, may cause a tire to blow out.
If you do use a service station pump, make sure the pressure gauge is working and
then use very short bursts of air to inflate the tire to the correct PSI, taking care to
avoid sudden over inflation. If you exceed the recommended PSI, release the excess
pressure immediately.
Charging the Battery
Your City Scooter may not have a fully charged battery. Therefore the battery must be
charged prior to use.
Initial charge time: 18 hours, and never charge the battery longer than 30 hours.
• Recharge time: up to 12 hours, and never charge the battery longer than 30 hours.
• Runtime: Up to 30 minutes of continuous ride time
• Average battery life: 250 charge/discharge cycles