Flushing the dispensing system:
It is important to rinse out the dispensing system before starting to use your appliance:
•
Put the base water tank onto the water chiller; ensure that the tank sits into the slots located in top of
the water chiller.
•
Put the upper water tank on the base water tank and put the filter into the upper water tank.
•
Fill the water tanks with cold tap water.
Note: Do not fill the water tank too quickly; because when you fill the upper water tank, the water will go
through the filter and enter into the base water tank and the water chiller. When the top of the filter is
immersed in water, please wait a couple of seconds to allow the water to enter into the base water tank.
•
Turn the dial on the lid to current month. The change date will show the second successive month from
the start date.
•
The first jug of filtered water may contain some black dust released from the carbon filter. Although this
is not harmful, we recommend that you flush the filter and discard the first batch of filtered water. Press
the Normal Water Tap and Chilled Water Tap together until the entire contents of the water tank has
been filtered and dispensed. It is important not to interrupt the water flow during this time. It is normal
for a small amount of unfiltered water to remain in the bottom of the water tank.
•
The flushing procedure should be repeated with Cold Tap Water to ensure there is no residual taste.
Note: During the flushing process, the appliance may splutter as the air inside the filter is replaced by
water. You will notice a change in the filtering noise when the water tank is almost empty.
•
Do not fill the top water tank above the lip below the lid.
•
When flushing the filter using the Cold Tap Water for the first time, while pressing the Normal Water
Tap and Chilled Water Tap, no water will be dispensed until the tank is almost empty as the water will
be filling the internal cooling reservoir.
•
After flushing the filter, the water will need to chill. Leave the appliance plugged in and wait for the
water to chill. On first use the appliance should be plugged in and left overnight to chill.
•
The light may flicker on and off as chilled water is dispensed and if the ambient temperature increases.
The fan will also come on in these conditions and will remain on until the water is chilled again.
Float
The float is an important part of the Water Chiller. It is
used to gauge the water levels and prevent any leakages.
To ensure the float is fitted correctly:
1. Unscrew the bottom of the float housing to expose
the float.
2. The float has a rubber stopper on the tip. This
rubber tip must be pointing up towards the base
water container.
3. Tightly screw the ring back on the housing.
Filtering room temperature water:
Place a glass or jug under the spout and press the Normal Water Tap. To filter the entire contents of the water
tank, place a large container or jug (at least 4.5 liters) under the spout.
Filtering chilled water:
Place a glass or jug under the spout and press the Chilled Water Tap. The unit will dispense up to 3 cups
(about 0.8 liters) of chilled water at a time. If you’ve dispensed more than two cups one time, the unit will
require about 1.5 hours to chill the whole water reservoir. The chilled water ready light will go OFF when the
unit is able to dispense chilled water again.
Float Housing
Float with rubber stopper
