CAUTION: To avoid of electric shock, you must always switch off and unplug the fan before cleaning.
ROUND BASE ASSEMBLY
1.
Unscrew the Fastener Ring
and Base Locking Nut from
the Stand Assembly.
2.
Insert the Stand Assembly
through the hole in the centre
of the Base and twist into
position.
3.
Turn the Round Base upside
down with the Stand
Assembly, facing the floor and
place the Base Weight
Support to the bottom of the
Base. Tighten the Base Weight
Support to the Stand Base by
screwing the Fastener Ring
and clips into place. Lastly, tighten the grill locking screw at the bottom of the Rear Grill.
4.
Place the Control box on the holes of the Telescopic Inner, then fix it with the Control box by the
holder screw.
OPERATING INSTRUCTIONS
1.
Place the fan on a dry, flat, level and sturdy surface.
2.
Plug the power cord into the wall power socket.
3.
Select your desired speed setting, switch to 1 for Low speed, 2 for Medium speed & 3 for High
speed.
4.
Press down on the oscillation knob (located on the motor) to activate oscillation function. Lift the
oscillation knob upwards to fix the fan in one direction.
5.
You can turn the height adjustment knob to adjust the height of the Pedestal Fan.
6.
To turn off the Pedestal Fan, Switch to the 0 button on speed setting.
CARE & CLEANING
•
Your appliance must be switched OFF via the main power supply and unplugged before
proceeding with any cleaning.
•
Switch the speed setting to the 0 position and unplug the fan from the power outlet.
•
Use only a soft, damp cloth to gently wipe the fan and dry well.
NOTE: If the power cord set of this appliance becomes damaged, discontinue use. Repairs should be
undertaken only by a qualified technician.
NOTES:
•
Before inserting the plug into a power outlet, make sure that the correct voltage being used
corresponds to what is indicated on the rating label, and that the socket has an earth facility.
•
Remove the cable tie and unravel the cord set before operation. Connect the plug into an
electrical socket and switch on at the wall.
•
Gently handle the motor house, tilt up or down until the assembly locate into the desired
position.
