PLACEMENT
This heater is inteded for freestanding. It is not to be mounted on walls, ceiling or floors. Choose a
location where there is at least 1m clearance of either side from drapery or any other furnishing.
Freestanding Installation
The heater must always be used in the upright position. When using as a freestanding, do not operate
without the feet in place.
1. Ensure the heater is unplugged and power is switch off.
2. Set the heater upside down.
3. Locate the two mounting holdes at each end of the heater base.
4. Align the mounting holes on the feet to the heater base and slide the feet-in so that the moulded
tabs on the feet are locked in with the heater body.
5. Secure each feet with two machine screws, supplied with the unit. The heater is now ready to
use.
ASSEMBLING INSTRUCTIONS
Before using the heater, the feet (supplied separately in the carton), must be fitted
to the unit. These are to be attached to the base of the heater using the 4
self-tapping screws provided, taking care to ensure that they are located correctly
in the bottom ends of the heater side moldings.
OPERATING INSTRUCTIONS
1. Before inserting the plug into an electrical outlet, make sure that the
electrical supply in your area matches that on the rating label on the
unit. Plug the heater into a wall socket once this matches.
2. Place the heater on a flat, smooth and firm surface. If on carpet,
ensure that the carpet does not obstruct the air vents on the underside
of the body.
3. Adjust the thermostat knob fully in a clockwise direction to a desired
position, towards the maximum setting.
4. Turn on the unit by selecting the desired Heat settings. For minimum
NOTE:
It is normal when the heaters are turned on for the first time or when they are turned on after
having not been used for a long period of time, the heaters may emit some smell and fumes. This will
disappear when the heater has been on a short while.
INSTALLATION CAUTIONS:
•
Any electrical wiring required for installation, must be carried out by a qualified licensed electrician.
•
Do not mount directly below or in front of a socket outlet.
•
Do not install behind doors.
•
Do not use outdoors. For indoor use only!
